Marble, a metamorphosed limestone prized for its hardness and variety, is quarried in north Georgia near Tate, in Pickens County. This marble has been used extensively for gravestones and in buildings throughout the United States, including the U.S. Capitol. Sixty percent of the monuments in Washington, D.C., in fact, are made from Georgia marble.

The earliest known use of Georgia marble dates to 1400, when effigies, bowls, projectile points, and other necessities were carved out of native marble. These early artifacts, found in Pickens County, are part of the permanent exhibit at the Etowah Mounds near Cartersville.

Early Industry

The area’s marble industry began after the mid-1830s, when Henry T. Fitzsimmons, an Irish stonemason, was traveling through north Georgia and discovered outcroppings of surface marble in the Long Swamp Valley of what was then Cherokee County. He immediately obtained the land, opened the Long Swamp Marble Company, and quarried the marble by very crude means. He then carved monuments and memorials that were sold throughout the area.

Georgia State Capitol
Georgia State Capitol

Courtesy of Georgia Department of Economic Development.

Georgia’s next entrepreneur in the marble industry was Samuel Tate, who in the 1830s purchased land lottery tracts in north Georgia, much of which included large marble deposits. In 1845 Tate signed an agreement with James Ferrel, James C. Holmes, and Gideon Roberts, all from Alabama, that allowed for quarrying on his land. There is no evidence, however, that this agreement was ever enacted. In 1850, while continuing to farm, Tate became a partner in a marble company that opened a quarry in the vicinity of the present Georgia Marble Company in the town that later became known as Tate.

Georgia Marble Company

By 1880 the marble industry was defunct, lacking the necessary capital and transportation network to thrive. The arrival of the railroads by 1883 to Pickens County, with the establishment of the Marietta and North Georgia Railroad system, revitalized the industry by providing a means of transporting blocks and finished marble products. Northern capitalists invested in the industry, and the Tate family created the Georgia Marble Company in 1884. Marble finishing plants sprung up in Pickens County; Ball Ground and Canton in Cherokee County; and Marietta in Cobb County.

Georgia Marble Company
Georgia Marble Company

Courtesy of Georgia Archives.

In the late 1880s Samuel Tate’s sons, Stephen Clayton Tate and William Tate, increased their landholdings in the area and assumed a more direct role in the management of the marble industry. The family signed a twenty-five-year lease of the marble quarries with an option for renewal. Other companies attempted to capitalize on the industry with limited success, but the Tate family successfully expanded the markets for its Georgia Marble Company stone. In addition, Stephen and William Tate were on the board of directors of the Etowah quarry, which opened in 1890 and provided the first truly pink marble.

By 1900 there were 110 men employed in the marble industry in Tate. Over the next ten years, the number of workers increased to 182, and the Georgia Marble Company began to construct employee housing near the marble quarries and mills. Again, however, the company lacked the capital to make needed improvements in the quarrying and finishing operations, and the net profit in 1900 was a little more than $14,000.

Tate and Foremen
Tate and Foremen

Courtesy of Georgia Archives.

Fortunately for the industry, Samuel Tate, Stephen’s son, was named president and general manager of the Georgia Marble Company in 1905. With the help of family and friends, he acquired 6,791 shares of the stock. He immediately added equipment, changed procedures, cleared quarries, and built additional houses for the workers. By 1906 the company’s profit had risen to more than $120,000.

In 1909 the twenty-five-year lease on the quarries expired and was renegotiated with the Tate family. The resulting transaction made the Georgia Marble Company joint owners of certain marble properties with the Stephen C. Tate Estate, an arrangement that continues to this day. Between 1917 and 1920, Georgia Marble Company president “Colonel Sam” Tate, as Samuel Tate was called, bought out the surrounding finishing plants and hired many more employees to complete “finished” marble products in the mill. By 1924 the state geologist of Georgia reported that $1,867,000 worth of Georgia marble had been quarried in Pickens County.

Georgia Marble Company
Georgia Marble Company

Courtesy of Georgia Archives.

During the marble boom of the 1930s, Georgia marble was utilized for the Longworth House Office Building in Washington, D.C., the Puerto Rican capitol, the New York Stock Exchange, and the Cleveland Federal Reserve Bank and Public Library in Ohio. The value of the Georgia Marble Company was reported to be more than $3.7 million. The company’s success continued through 1932. In 1933 losses were reported to be $225,000, and an attempt to sell the company for $3 million failed. By the time Colonel Sam Tate died in 1938, the company was struggling for solvency again.

In 1941 the board of directors developed an extensive financial restructuring plan to keep the company solvent, a plan that also improved working conditions and increased employee benefits. The electrical plant was sold to the Rural Electrification Administration, and some holdings were liquidated, but monument sales continued to be strong, due to the expertise of the personnel in the design and finishing plant. By 1942 sales for monuments totaled just less than $1 million, and by 1950 they accounted for 51 percent of gross sales. The Calcium Products Division was created in 1947, developing a market for ground and pulverized marble products. Utilizing “waste” marble in the beginning, this section of the industry became the primary product by the late 1980s.

Ground Marble Products
Ground Marble Products

Courtesy of Georgia Archives.

Between 1940 and 2003, the Georgia Marble Company changed hands several times. The Jim Walter Corporation purchased the company in 1969 for $23 million. Succeeding owners were Kolberg, Kravis, Roberts and Company; Hillsborough Holdings Corporation; First Chicago Corporation; and IMERYS. In 2003 Polycor Inc. of Quebec City, Canada, purchased the company. Polycor sells approximately 75 percent of its Georgia marble to governments all over the world. The company spent $5 million to upgrade the plant and equipment, and in July 2005 it announced that Tate would be Polycor’s U.S. headquarters.

Marble Slabs
Marble Slabs

Courtesy of Georgia Archives.

Native Georgia marble has been used within the state on such structures as the state capitol, Lenox Square Mall in Atlanta, and several buildings on the Emory University campus.

Share Snippet Copy Copy with Citation

Updated Recently

A More Perfect Union

The New Georgia Encyclopedia is supported by funding from A More Perfect Union, a special initiative of the National Endowment for the Humanities.

Image

Georgia State Capitol

Georgia State Capitol

The state capitol building, completed in 1889, features a cornerstone, interior floor and steps, and many walls made of Georgia marble. Marble mined in the state was also used to construct 60 percent of the monuments and the U.S. Capitol in Washington, D.C.

Courtesy of Explore Georgia, Photograph by Ralph Daniel.

Georgia Marble Company

Georgia Marble Company

A gang saw at the first plant built by the Georgia Marble Company in Pickens County is pictured circa 1885. The company was founded in 1884 by Samuel Tate, who in the 1830s purchased large tracts of land containing marble in north Georgia.

Courtesy of Georgia Archives, Vanishing Georgia, # pck285-85.

View on partner site

Tate and Foremen

Tate and Foremen

Colonel Sam Tate (second from left), the grandson of Georgia Marble Company founder Samuel Tate, poses with a group of foremen at the Pickens County plant, circa 1925. Colonel Sam served as president of the company from 1905 until his death in 1938.

Courtesy of Georgia Archives, Vanishing Georgia, # pck111-82.

View on partner site

Georgia Marble Company

Georgia Marble Company

Colonel Sam Tate, the president of the Georgia Marble Company, oversees the production of a marble bench in the Pickens County plant, circa 1930. The marble industry in the state prospered during the early 1930s but suffered losses from 1933 through the rest of the decade.

Courtesy of Georgia Archives, Vanishing Georgia, # pck250-85.

View on partner site

Ground Marble Products

Ground Marble Products

Sacks of ground or pulverized marble are produced at the Calcium Products Division of the Georgia Marble Company in Tate (Pickens County), circa 1950. The division was created in 1947 to sell "waste" marble, which is used as filler in paints and plastics. Ground marble products became the company's main product by the late 1980s.

Courtesy of Georgia Archives, Vanishing Georgia, #pck253-85.

View on partner site

Marble Slabs

Marble Slabs

Marble slabs used to make columns during reconstruction work on the U.S. Capitol in Washington, D.C., are cut at the Georgia Marble Company in Pickens County, circa 1958.

Courtesy of Georgia Archives, Vanishing Georgia, # pck043-82.

View on partner site

Marblehill Quarry

Marblehill Quarry

Workers for the Georgia Marble Company sit for a portrait during the 1920s at the Marblehill Quarry in Pickens County. Marble from Pickens County is reported to have been used in around 60 percent of the monuments in Washington, D.C.

Courtesy of Georgia Archives, Vanishing Georgia, #
pck018-82.

View on partner site